Socialwifionline intergation with mist

Juniper Mist Cloud Controller

Setting up a custom guest portal page with Juniper Mist involves creating a captive portal and configuring parameters for authentication on the RADIUS server. Here are the steps you can follow:

Access your Juniper Mist account through the Mist Cloud Portal.

Create a WLAN

If you haven’t already, create a new WLAN by navigating to Networks / WLAN / Create WLAN.

SSID Name: Set the SSID name (e.g., “Guest WiFi”).
WLAN Type: Select Guest Access or Open, depending on your requirements.

Configure Captive Portal

Go to Network and navigate to SSID.


Set the Portal URL:


In Captive Portal Type, choose External Captive Portal.                                                                                     

RADIUS Server Configuration

Configure the RADIUS server to authenticate users who access the guest Wi-Fi:



Navigate to the WLAN Settings / RADIUS Server section.
Primary RADIUS Server: 192.250.224.84
Authentication Port: 1812
Accounting Port: 1813
You should set the shared secret for both RADIUS servers (contact our office for shared secret).     

Enable Accounting


In the RADIUS configuration, enable accounting to track user sessions and bandwidth.
Make sure that the Accounting Port is set to 1813.

Configure Authentication Method

Choose the authentication method (e.g., WPA2-Enterprise if you’re using a captive portal with authentication).
Ensure the RADIUS server is configured correctly.

Test Captive Portal

Connect a test device to the SSID and verify that the captive portal redirects to the specified URL (https://connectwifi.cloud/login).
Complete the login process using the credentials created on the Cloud WiFi portal and authenticated via the RADIUS server.

These steps should guide you to setting up your guest portal page with Juniper Mist.

    Server Information



      • Related Articles

      • Ubiquiti UniFi Cloud Controller

        Ubiquiti UniFi Cloud Controller This article describes the installation and configuration steps for Ubiquiti UniFi Cloud Controller in Legacy mode. Instructions in this guide are only for older UniFi controllers with Legacy mode and shouldn’t be used ...

      • Grandstream GDMS Cloud

        This article describes the installation and configuration steps for Grandstream GDMS Cloud devices. Connecting Log in to your Grandstream Cloud account at https://www.gdms.cloud/gwn Go to Settings / Wi-Fi and configure: WiFi: Enabled SSID: GuestWiFi ...

      • Extreme Networks Campus Controller

        This article describes installation and configuration steps for the Extreme Networks Campus Controller. Connecting Log in to your Extreme Networks Campus Controller , go to the Configure/AAA Policy page and configure the following: Name: ...

      • TP Link Omada Controller

        This article describes the installation and configuration steps for TP-Link Omada Cloud-Based Controller. You will need Omada Controller v5.3.1 or above in order to proceed. Our test was performed with Omada Cloud controller v5.9.41. CONNECTING Login ...

      • Ruckus Virtual SmartZone

        Ruckus Virtual SmartZone This article describes the installation and configuration steps for Ruckus Virtual SmartZone controller. Our test was performed with controller version 3.6.2.0.222, Control Plane Software version 3.6.2.0.63, and AP Firmware ...